Plug the SLD (Green) female end into gray connector position #17 on the female side. Remove this wire completely by releasing it from both female & male ends of the gray sub-connector. Now button up the DB9 cover with the new wires.įind #17 on the FEMALE side of the gray sub-connector. Insert small pins from the wire set into DB9 positions: The SLD wires being added are generally green color. Remove DB9 cover - Note that only 3 pins are in the BMS USB Cable normally. PART 2: ADDING SLD WIRES FROM BMS USB CABLE TO HARNESSĢa. I didn’t need one, don’t know how to use one, but here’s a link: Good Luck! The pins can be removed from the DB25 using a D-Sub Pin Extraction Tool. If the 23 wire (purple) goes to goes to the MALE side of the white sub-connector, it MUST BE SWAPPED with the like colored 11 wire (purple) that it is paired with. If the 22 wire (green) goes to the MALE side of the white sub-connector, it MUST BE SWAPPED with the like colored 10 wire (green) that it is paired with. Do a continuity check w/ multi-meter to confirm. 1 (green & purple respectively on my harness) MUST go to the FEMALE white sub-connector. JB4 harnesses older than 2010 may need to have the green or purple wires swapped.ĭB25 Wires 22 & 23 Fig. PART 1: IS YOUR HARNESS READY FOR THE G5 BOARD?
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |